Warhammer
Complete guide on our Warhammer modu
Last updated
Was this helpful?
Complete guide on our Warhammer modu
Last updated
Was this helpful?
Normal mode
Monitor mode
Which Mode do I use?
Monitor mode will only monitor and ping your watch tasks when they detect the item you're monitoring is in stock
Normal mode is your checkout task that is to be used for normal checkout flow. You can select a watch task, and this task will then sleep until the monitor picks up the item as being in stock.
What does Profile mean?
Select a Profile you want to use and that profile information will be used when checking out items. Warhammer uses guest checkout, so all information is pulled from the profile. Warhammer is also very relaxed about Jigging, so minor 3 letter jigs tend to work.
What type of Proxies should I use?
You need to use high quality proxies, we recommend fast ISP’s. You can use these on both monitor and normal mode.
What is the Product URL?
The URL will show on the website with queryID at the end, example below.
What is QTY?
The number of items you want in one order. Warhammer usually limits to 1 per order, unless stated otherwise on the product page.
What is Delay?
The time in milliseconds the bot will retry to checkout after it encounters an error
You can start your delays around 2000 and adjust accordingly due to proxy quality
What is Monitoring Delay?
The time in milliseconds the bot will monitor the product
You can start your delays around 3500-4000 and adjust accordingly due to proxy quality
What is Reset Delay?
The time in milliseconds the bot will monitor the product again after it has detected the item is in stock
You can start your delays around 5000 and adjust accordingly due to proxy quality
Top tip for Warhammer:
Drops always take place at 9.55am on a saturday, for a drop you don’t need to run monitor mode, and instead can just run normal mode, starting 30-60 seconds before drop time.
Links can be found, in the New & Exclusive section of the website, under the category “Pre-Orders”
This full URL isn’t needed in the bot, and you can remove the ? and everything after it, so the URL you’d run in the bot will be below.
